31 articles
Instruction Manuals
Every manual we publish, in one place. Download, print, or keep it on your phone at the shoreline.
- Pulling My Leg Jack Instructions Instructions for using the Pulling My Leg Jack.
- Folding Pier Cleat Installation Easily tie up your boat with the Folding Pier Cleat.
- Bolt on Footpad Installation Installation instructions for our Bolt On Footpad
- T & L Mount Installation Install a T or L mount to add a platform or turn off the main run of your pier.
- Adjustable Stairs Installation Assemble and fit adjustable stairs to your pier.
- Single Board Strap Installation Fit the single board strap to secure an individual deck board.
- Side Step Installation Fit a side step to give easy access into the water from the side of your pier.
- Section Coupler Installation Join two pier sections side by side with a section coupler.
- Vertical Pier Mount Installation Mount your pier vertically against a seawall.
- Horizontal Pier Mount Installation Mount your pier horizontally against a seawall or shoreline structure.
- Pier Installation The full clip and flip installation, from the starting section to the end of your pier.
- Panel Storage Rack Assembly Assemble the panel storage rack brackets for off-season panel storage.
- Panel Clip Installation Secure deck panels to the pier frame with panel clips.
- Ladder Installation Mount a gripper-mount ladder to your pier.
- Kayak Stabilizer Ladder Attachment Fit the stabilizer attachment to a ladder for easier kayak launching and landing.
- Adjustable Kayak Rack Assembly Assemble and mount the adjustable kayak rack. 2022 revision.
- Jack of All Heights Use the Jack of All Heights to raise and lower pier legs during installation and removal.
- Interior Leg Conversion Kit Convert a frame to interior legs using the conversion kit.
- Gripper Ramp Installation Install a gripper ramp to start your pier from the shore. 2025 revision.
- Giant Muck Pad Installation Fit giant muck pads to keep legs from sinking on a soft or mucky lake bottom.
- Footrest Installation Fit a footrest to your bench or seating position.
- Extraction Boom Installation Use the extraction boom to install and remove pier frames without getting into the water.
- Deep Water Bracing Installation Brace your pier for deeper water, where legs run longer and need extra support.
- Corner Cutter Installation Fit the corner cutter to trim a corner section of your pier.
- Cincher Parts Replacement Replace worn or damaged parts on a cincher.
- Chair with Gripper Mount Installation Mount a chair to the pier using the gripper mount.
- Bench Arms with Cup Holder Installation Add the pair of arms with cup holders to an assembled 5' bench.
- Under-Mounted Bench Drawer Installation Fit the under-mounted drawer beneath a 5' bench for dry storage on the dock.
- 5' Bench Assembly Assemble the 5' bench and mount it to your pier frame.
- Angle Slip Adapter Installation Fit the Angle Slip Adapter to set your slip at 45 degrees and save room along your shoreline.
- Adding a Fascia Mount Bolt to an Older Mount Retrofit instructions for adding a bolt to a fascia mount installed before the current design.
Other topics
Still stuck?
Our team knows these docks inside and out. Give us a call and we will walk you through it.
Call (715) 941-4707