1. Wrap the clamp around the leg at about the waterline. |
2. Put the 2″ bolt partway through one of the holes. |
3. Attach one end of the deep water brace to the bolt. |
4. Close the clamp and run the bolt through. |
5. Add the spring. |
6. Lightly attach the wing nut. |
7. Pivot the deep brace arm as far up as it will go |
8. Tighten the wing nut as tightly as possible. |
9. The clamp will remain loose so you can lower the arm. |
10. Lower the clamp/arm as per the instructions. |
11. Then bring the top of the arm over to the other leg. |
12. As the arm pivots over, the clamp will tighten up and hold fast. |