|1. Wrap the clamp around the leg at about the waterline.
||2. Put the 2″ bolt partway through one of the holes.
||3. Attach one end of the deep water brace to the bolt.
|4. Close the clamp and run the bolt through.
||5. Add the spring.
||6. Lightly attach the wing nut.
|7. Pivot the deep brace arm as far up as it will go
||8. Tighten the wing nut as tightly as possible.
||9. The clamp will remain loose so you can lower the arm.
|10. Lower the clamp/arm as per the instructions.
||11. Then bring the top of the arm over to the other leg.
||12. As the arm pivots over, the clamp will tighten up and hold fast.